Description
Includes the (4) upper grommets and the (4) lower screw bosses for the rear outside engine vent.
Sold as a complete set. (Screws are NOT included)
Made from high quality 3D printed flexible TPU.
Priced per set.
Installation:
- Remove the old plastic bits (should be easy as they are most likely cracked or missing anyhow).
- Push the lower Screw Bosses into the square holes until seated.
- Stick the flat side into the upper Grommet holes.
- Push the slot with a flat blade screwdriver so that it deforms and the top half seats into the hole.
- I put a dab of vaseline on the prongs on the vent just to make it that much easier.
- Insert lubed prong ends into upper grommets.
- Carefully insert the screw and fasten until sung.
- Crack a beer and relax. 😉
Gregory R. (verified owner) –
Once again, an elegant solution to a part that is hard to find for Vanagon’s. Our Vanagon’s would be a lot more sad if Uniwerks didn’t exist.